MAXIM INTEGRATED / ANALOG DEVICES MAX5064BATC+. Datasheet & Stock

The MAX5064BATC+ is a 125V/2A, high speed, half-bridge MOSFET driver in 12 pin TQFN package. The high-frequency, 125V half-bridge, N-channel MOSFET driver drive high and low-side MOSFETs in high voltage applications. Driver is independently controlled and its 35ns typical propagation delay from input to output are matched to within 3ns (typ). The high voltage operation with very low and matched propagation delay between drivers and high source/sink current capabilities in a thermally enhanced package make this device suitable for high power, high frequency telecom power converters. The 125V maximum input voltage range provides plenty of margin over 100V input transient requirement of telecom standards. A reliable on-chip bootstrap diode connected between VDD and BST eliminates need for an external discrete diode. This device is used in telecom half-bridge power supplies, two switch forward converters, full-bridge converters, active-clamp forward converters and power supply modules.




Supply voltage range is 8V to 12.6V

Operating temperature range from -40°C to 125°C

Two inputs per driver that can be either inverting or non-inverting

2A peak source and sink current drive capability

TTL logic level inputs with hysteresis

Programmable break before make timing

Up to 1MHz combined switching frequency while driving 100nC gate charge

Up to 15V logic inputs independent of input voltage

Low input capacitance is 2.5pF and low supply current is 200μA

Instant turn-off of drivers during fault or PWM start-stop synchronization





Applications


Power Management,

Motor Drive & Control





Warnings
Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.